Hi Peter I have a couple of Racl-Dana 5002s here. They give that message
when the back-up Li-batt has gone down or been replaced. There are a set of
buttones that you push to clear the message.
With the 5002 the clear is "special function 97.1 " I think the clear is by
pressing 0 (that is zero), SHIFT , SF (that is the special function key)
in sequence. That will clear the message if the batt is above 2.8V It should
stay clear.
I hope that helps.......my 5002s are not as useful as athey are wide band
rather than selective, and are "available" if anyone is interested
Cheers de Alan G3NYK
[email protected]
----- Original Message -----
From: "g3ldo" <[email protected]>
To: <[email protected]>
Sent: 01 February 2004 22:58
Subject: LF: Re: RF level meter
I have a Racal-Dana True RMS RF Level Meter 9303. It reads RF level OK but
I
get this flashing message
Er 01, which according to the operator card means "Memory Corrupted, refer
to handbook".
Snag is I don't have a handbook. There seems to be a lot of interesting
computing that can be don with this instrument if only it were working
properly.
Can anyone help?
Regards,
Peter, G3LDO
| 