I wondered who owned the S9+20 signal Alan!
73, Tom G3OLB
In message <001c01c2dec6$044de5a0$6507a8c0@Main>, Alan Melia
<[email protected]> writes
Hi all, I thought this little episode might prove interesting and it
certainly finds a use for the "below 50MHz" part of a hand-held scanner. I
have an AOR 2700 which purports to operate down to 100kHz, but like a lot of
this kind of kit is very deaf down there. I did think it might be useful for
DFing TV interfence, but it is too deaf even for that, without a pre-amp.
I restrung my 60m-top Marconi last weekend and was disappointed to see that
the tunning when paralleled with my 30m top inv-L was not at the original
position. As it is a receive aerial is is strung with 1mm PVC coated wire. A
quick measurement of the tuning inductor indicated only 80pF more capacity,
which I guessed would mean a break inside the insulation about 16m from the
feed point (5pF / m). After a little thought and a couple of coffees, I
plugged the end of the unloaded 60m wire into the 600ohm output of the PS-12
(W&G SIG GEN) turned up full and with the interenal resistor set to "0". I
then walked down the wire (now dropped to the ground again), running the
wire at right-angles over the closed telescopic aerial on the AOR2700. The
"S-meter" gave fullscale on AM, and about 15m down the wire it dropped
significantly ( to "S3"). A quick waggle of the wire confirmed two breaks at
that point. I was quite pleasantly surprised that point indicated by the
scanner s-meter was with an inch of the break. After a quick soldering job
and a tape-up the aerial tuning inductor was back to where it was expected
to be.
I know its not rocket science but its nice when these little tricks really
work. The feed voltage from the PS-12 was about 0.7V r.m.s. It also proved
my contention that a wide coverage receiver is one of the most useful bits
of test gear you can have (I might add "portable" to that as well now!!)
Cheers de Alan G3NYK
[email protected]
--
Tom Boucher
'Hedgerows'
Sheldon
Honiton
Devon EX14 4QS
|
