Return to KLUBNL.PL main page

rsgb_lf_group
[Top] [All Lists]

RE: LF: Tesla Coil as an antenna

To: [email protected]
Subject: RE: LF: Tesla Coil as an antenna
From: "Tom Tishken KD4WOV" <[email protected]>
Date: Thu, 31 Jan 2002 18:28:50 -0500
Importance: Normal
In-reply-to: <[email protected]>
Reply-to: [email protected]
Sender: <[email protected]>
One other note I just thought of. Here in the US displays for Tesla coils
must be in a shielded an environment, i.e. no radiation or EMI released from
the shielded enclosure. not sure if that was the case there or not.

-----Original Message-----
From: [email protected] [mailto:[email protected]]On
Behalf Of g3ldo
Sent: Thursday, January 31, 2002 5:39 PM
To: [email protected]
Subject: Re: LF: Tesla Coil as an antenna


>>   I have not experimented in a while with my partially built tesla
coil,
>> but has anyone used their Tesla coil as an antenna for ELF or other
Freqs?

I assume that a typical tesla coil is a rather short and fat structure. I
am not sure that in this case the magnetic field can be ignored, compared
to the electric field. And since a Tesla coil has rather small
dimensions -
compared to other LF transmitting antennas - I'm afraid that it will have
a
very low efficiency.
BUT ... since you have the Tesla coil available I would certainly
recommend
to do some tests (that's what all the fun is about).
Over two years ago I reported on the Tesla coil as a radiator.
I was operating at radio station at Amberley Museum and was told that there
could be some QRM because of a Tesla group who had set up at the Electricity
Hall. I did not experience any QRM so after my operating stint I drove my
car near to where some of the larger coils were being tested. I was told by
the group that the frequencies in used depended on the size of the coil with
the large ones on about 130kHz and the one very big one on 70kHz.
These coils produced some very spectacular displays. I had my old 707 rig
with a converter with me and used a 2m length of wire as an antenna. The rig
was located about 100m from the coils. I tuned around the LF bands while
some of these monsters were being fired up and heard - nothing!
The receiver was working because I could hear the lager commercial stations
without difficulty.
It could be that all the energy was being dissipated the spark - but I would
have expected to receive something.
All these big coils were using the rotary spark gap method of firing the
primary coils - a spectacular display in themselves.

Regards,
Peter, G3LDO

e-mail <[email protected]>

Web <http://web.ukonline.co.uk/g3ldo>





<Prev in Thread] Current Thread [Next in Thread>