Return to KLUBNL.PL main page

rsgb_lf_group
[Top] [All Lists]

LF: LF use in G Land

To: [email protected]
Subject: LF: LF use in G Land
From: "Larry Kayser" <[email protected]>
Date: Thu, 20 Sep 2001 08:11:03 -0400
References: <000501c14158$f5e46cc0$8130073e@default>
Reply-to: [email protected]
Sender: <[email protected]>
Greetings All in G land.  The following found its way to me and I post it so
some of you can follow it up and see what some people have planned for LF.

Regards, Larry, VA3LK


-------------------------------------Insert

From: "Sykes, Bob" <[email protected]>
To: <[email protected]>
Sent: Wednesday, September 19, 2001 10:49 AM
Subject: 134kHz transmitter in the U.K.




Greetings,

We are looking at providing a short range RFID system to the U.K., and I
am
tasked with
determining the regulatory requirements for this system.  It incorporates
a
low power
transmitter/receiver operating at 134kHz.  I am familiar with the LVD and
EMCD requirements,
but unable to determine RTTE applicability, or whether U.K. National
regulations apply.

Any help would be most appreciated.

adTHANKSvance,

-Bob Sykes
Marconi Commerce Systems


-------------------------------------------
This message is from the IEEE EMC Society Product Safety
Technical Committee emc-pstc discussion list.

Visit our web site at:  http://www.ewh.ieee.org/soc/emcs/pstc/

To cancel your subscription, send mail to:
     [email protected]
with the single line:
     unsubscribe emc-pstc

For help, send mail to the list administrators:
     Michael Garretson:        [email protected]
     Dave Heald                [email protected]

For policy questions, send mail to:
     Richard Nute:           [email protected]
     Jim Bacher:             [email protected]

All emc-pstc postings are archived and searchable on the web at:
    No longer online until our new server is brought online and the old
messages are imported into the new server.

---------------------------------------------------------



<Prev in Thread] Current Thread [Next in Thread>