HI Chris. Why you have a negative low level? Also in the previous post in channel B: 73 Claudio ik2pii -- ZE-Light e ZE-Pro: servizi zimbra per caselle con dominio email.it, per tutti i dettagli cli
HI Chris. Why you have a negative low level? Also in the previous post in channel B: 73 Claudio ik2pii -- ZE-Light e ZE-Pro: servizi zimbra per caselle con dominio email.it, per t
If the HIGH level is too low the following divider can't divide properly! If the LOW level can sink few mA of current from the IC the divider can be degraded! Random divide factor can be a consequen
Hello Claudio, Thanks Claudio, but how do I fix this issue? I can rebuild an F1 engine, but this is outside my comfort zone :) -- Best regards, Chris mailto:[email protected]
If you only have supply of 0/5V you cannot have a negative '0' level. If your scope shows it, then it is possible your scope ground is not connected properly yo the -ve rail but instead to somehti
Hello Andy, That's good to know and the lead lengths are a bit (possibly a lot...) excessive, so grounds are scattered. I have a few DIP dividers to play with on the breadboard so I don't scrap anoth