Return to KLUBNL.PL main page

rsgb_lf_group
[Top] [All Lists]

LF: RE: Re: Trees as antenna supports

To: [email protected]
Subject: LF: RE: Re: Trees as antenna supports
From: "Ashlock,William" <[email protected]>
Date: Mon, 11 Mar 2002 15:56:56 -0500
Reply-to: [email protected]
Sender: <[email protected]>
Hi Roy,

Don't think a fishing rod would work too well if you were standing in the
middle of a forest and had only a small opening in the branches, overhead,
to shoot a projectile through. I used to think that placing a loop wire in
this situation would be impossible; not now.

Bill A

PS: I like Tom's suggestion about using orange monofillament line. Hard to
see the blue stuff I've been using. Hope it's available in a large spool
that allows free-feed off the end.

Here is a far better way to get high above 100 ft or more. I know from
experience, I have several trees as supports. Use a small fishing rod, they
are accurate. And you can get higher than 100 foot or 30 mtrs with this
arrangement ;-) forget about bows and arrows hahahaha.

Regards & Best Wishes
Roy
MM0LOS

Dear LFers

Just a few more words of advice to the would-be Robin Hoods or Davids
(as in vs. Goliath) amongst us.

1) Use a proper lead weight with an eye in it instead of a steel nut.
These are obtainable along with the catapult in any angling shop and are
available in various weights. I use a 6 or 8 ozs one.

2) Use the fluorescent orange coloured mono-filament nylon line. Much
easier to see when it is hanging down through the branches.

3) If the weight doesn't reach the ground on the other side of the tree,
don't immediately pull it back but ease it back and forth to try and
bring it down.

4) If that doesn't work, pull it back SLOWLY. If you do it fast, the
line will wrap itself around a branch and you will never get it down.
Do not pull with all your might as you stand a good chance of injuring
yourself as the weight flies towards you. (I speak from experience!)

5) Once you have the mono-filament across the highest point, use it to
pull back some thin cord and then use this to pull across the rope
halyard. Doing it in two stages lessens the risk of breaking the thin
nylon. I use polypropylene for halyards BUT I would think twice about
using polyprop for guying masts as it is attacked by UV and deteriorates
with age.


- I've not managed to get a halyard higher than 60 ft with a catapult,
mainly due to the poor elasticity of the synthetic rubber used as
previously noted. Anyone know of a good source of bows and arrows in UK?

73, Tom G3OLB





*********************************************************************
This footnote confirms that this e-mail message has been scanned for
the presence of known computer viruses by the MessageLabs Virus Control Centre. However, it is still recommended that you use
local virus scanning software to monitor for the presence of viruses.
*********************************************************************

*********************************************************************
This footnote confirms that this e-mail message has been scanned for
the presence of known computer viruses by the MessageLabs Virus Control Centre. However, it is still recommended that you use
local virus scanning software to monitor for the presence of viruses.
*********************************************************************



<Prev in Thread] Current Thread [Next in Thread>