Return to KLUBNL.PL main page

rsgb_lf_group
[Top] [All Lists]

RE: LF: Re: Static effects

To: [email protected]
Subject: RE: LF: Re: Static effects
From: "Talbot Andrew" <[email protected]>
Date: Wed, 20 Jun 2001 10:43:58 +0100
Reply-to: [email protected]
Sender: <[email protected]>
But much better still a bleed choke, making sure the inductance is high
enough not to affect the matching.  A good choke would be made from a
ferrite core and as it is not carrying any power a smaller core can be used
than would be the case for a matching transformer.  Make sure there are
enough turns to not saturate the ferrite with the highest RF voltage
present.  Saturation was almost certainly the case in an earlier posting
where a choke 'got hot'.
Use the formula    Vrms = 4.44.F.N.A.B   to calculate the Minimum turns
needed on any given core, using a B of around 0.1 Tesla for a good safety
margin.   All non-gapped ferrites designed for SMPSU transformers will have
more than enough inductance - up in the tens to hundreds of milli-henries -
when wound with enough turns to satisfy this equation.

Andy  G4JNT


-----Original Message-----
From: Tom Boucher [mailto:[email protected]]
Sent: 2001-06-20 08:40
To: [email protected]
Subject: Re: LF: Re: Static effects



Dave G3YMC wrote:
>
>If you feed your antenna, as many do, via a matching transformer (3C85 core) >then the >antenna and the line to the tx/rx will be automatically grounded. Another >advantage
>of this method of feeding antennas.

Well I do Dave but I have rather an odd T/R relay arrangement based on
single pole on/off relays which I had available. This means that when Tx supply is switched off, the antenna is connected to neither transmitter
nor receiver.

I didn't fit a bleed resistor as Andy suggests because I figured it
would have to dissipate a fair bit of power unless it was a high value, however even a high value will be adequate to discharge any build up of
static, I guess.

73, Tom



--
The Information contained in this E-Mail and any subsequent correspondence
is private and is intended solely for the intended recipient(s).
For those other than the recipient any disclosure, copying, distribution, or any action taken or omitted to be taken in reliance on such information is
prohibited and may be unlawful.


<Prev in Thread] Current Thread [Next in Thread>