Return to KLUBNL.PL main page

rsgb_lf_group
[Top] [All Lists]

RE: LF: Field effect versus bipolar tran sistors

To: [email protected]
Subject: RE: LF: Field effect versus bipolar tran sistors
From: "Talbot Andrew" <[email protected]>
Date: Thu, 31 May 2001 08:28:54 +0100
Reply-to: [email protected]
Sender: <[email protected]>
That centre tapped coil in the Decca transmitters is there to 'soak up'
high current pulses generated in the short switching interval when both FETs
may be on together - a few ns duration.  This comes about since the turn-off
time of power FETs is of longer duration than the switch on time.  The 15
ohm resistor across the coil is the damping to prevent high frequency
spurious oscillations.
In a SMPSU the there is a deliberate dead band generated at the cross over,
when both devices in a push pull pair are switched off, but this is
undesirable in a very high efficiency class E transmitter.
Andy  G4JNT



protective means against this. The centre tapped coil for instance, loaded by 15 ohms, located between both power FETs in the Decca 5501 PA output, seems to me to be such a protective device.

In a certain way, my complementary bipolar PA is even showing similarities to this basic Decca power amplifier block mentioned, such as two transistors in a totem pole configuration, the output employing a series resonant circuit . . . 73 Ha-Jo, DJ1ZB>


--
The Information contained in this E-Mail and any subsequent correspondence
is private and is intended solely for the intended recipient(s).
For those other than the recipient any disclosure, copying, distribution, or any action taken or omitted to be taken in reliance on such information is
prohibited and may be unlawful.


<Prev in Thread] Current Thread [Next in Thread>
  • RE: LF: Field effect versus bipolar tran sistors, Talbot Andrew <=