Well, my manual shows it in the parts list as 1uF 50V but since the
highest voltage in the RA1792 anywhere is 28V, and only 15V on the RF
AMP then I would have thought 25V would do.
However, the circuit diagram shows it as 0.1uF. As this coupling cap
is in a 50 ohm part of the circuit and the RA1792 is specified down to
150kHz (Yes, we all know it goes a lot lower !), 0.1uF gives a break
point at 32kHz so I guess 0.1uF is the correct value and the parts list
is wrong. C4, doing a similar function before the amp, is 0.1uF
Andy G4JNT
-----Original Message-----
From: tracey.gardner [mailto:[email protected]]
Sent: 2001-03-12 13:56
To: [email protected]
Subject: LF: Re: RE: Manual
Hi Andy
My 1792 manual shows C11 on the RF amp board to be 1uF 100v
whereas Brian's manual shows it to be 50v.
73s Tracey
> I have access to a RA1792 manual, is there any particualr
area / info
>you need ?
>Farnell do a radial 1uF ceramic capacitor - part no. 287-064.
>
> Andy G4JNT
>
--
The Information contained in this E-Mail and any subsequent correspondence
is private and is intended solely for the intended recipient(s).
For those other than the recipient any disclosure, copying, distribution,
or any action taken or omitted to be taken in reliance on such information is
prohibited and may be unlawful.
|
