Even better, Try KODI. It is a Free and Open Source internet tv system
that works across platforms and provides a plethora of tv program
sources including stuff from NASA (livestreams from ISS) ESA, iPlayer
etc. Many users simply use a RaspPi.
73 de pat g4gvw
On 18/05/16 22:23, Mal Hamilton wrote:
Chris
Avoid TV amps
Change over to Freesat to avoid all the problems you describe
It is cheap and easy to install yourself
De Mal/g3kev
G3KEV
On 18 May 2016, at 17:04, Chris Wilson <[email protected]> wrote:
18 May 2016
Long story, but since stopping LF 136kHz TX for a while in lieu of
some HF working all the digital TV's in the house freeze or totally
blank on all bands above top band, up to 50MHz when I transmit at more
than about 5 or 10W. I have a loft mounted UHF TV aerial feeding an
amplifier cum distribution box. It has an internal mains PSU. Without
it we receive hardly any channels. It's been fine for years, and I
have never had TVI. My HF set up is unchanged from when I had no
issues. I put the TV antenna co-ax direct into my SA and on circa 531
MHZ see a broad digiTV signal that's strong. If I TX on say 20 meters
at high power into my antenna I see zero change in the TV signal. I
have also fed the output of my HF TX (TS-590 Kenwood) into the SA via
an attenuator and the output looks spotless on all bands. However, if
I connect the TV aerial amp / distribution box up and look at the
output from it the TV signal immediately drops into the noise when I
TX. My neighbours have no issues at all.
This seems to have occurred since I have been active on LF, and I had a
stage where full power would trip the main RCD in the consumer unit,
so RF was getting into the mains. Is it conceivable something has
occurred to perhaps a mains filter in the TV amp? I looked inside the
plastic case and it has a small mains transformer that feeds feed
throughs into a screening can with all the RF stuff within it. If
there is any mains input filtering it must be on the low voltage side
of the transformer. The unit has a moulded on three pin mains plug, but
with a plastic earth pin, so the unit is not grounded.
Is it possible to make a mains input filter for a piece of equipment
that would filter 136kHz but not affect normal 50Hz mains operation?
Has anyone experienced anything like this?
I have ordered a new amp / distribution box of known make, and will
just try replacing it, but would also like to know if my LF activity
could have done this?
Thanks.
--
Best regards,
Chris 2E0ILY mailto:[email protected]
My part time LF grabber is at
http://www.chriswilson.tv/grabber.html
--
73 de Pat G4GVW
QTH Nr. FELIXSTOWE
EAST COAST UK
|
