Return to KLUBNL.PL main page

rsgb_lf_group
[Top] [All Lists]

LF: Earth experiments

To: [email protected]
Subject: LF: Earth experiments
From: "James Moritz" <[email protected]>
Date: Mon, 19 May 2003 17:53:52 +0100
Reply-to: [email protected]
Sender: <[email protected]>
Dear LF Group,

In the discussion over transmission lines, G3LDO said:

>Just a thought. Where should you connect the system to ground if the
>two components are some distance apart? Conventional wisdom suggests
>it should be under the loading coil.

It seems to me the earth connection should be where the return current flowing through the earth has the shortest, lowest resistance path, ie. directly under the antenna where the field is greatest. In an effort to test this, I did some experiments over the weekend.

The antenna arrangement here has an inverted L antenna, with a loading coil and matching transformer about 10m from the shack, fed through about 15m of 50ohm coax. The ground consists of 6 x 1m copper pipe ground rods, distributed within about 3m radius of the loading coil. The shack end of the coax was also grounded through various ground rods around the house, plus the mains earth and gas and water pipes. With this arrangement, the total loss resistance of the antenna/earth combination was 36ohms. Disconnecting the antenna ground, so that all the ground current had to flow via the shack ground resulted in 37 ohms loss resistance. Isolating the shack ground using a common-mode choke in the coax feeder, so all the current flowed in the antenna ground, resulted in 37 ohms loss resistance too. With both grounds connected, an RF ammeter showed that about 90% of the ground current flowed through the antenna ground rather than via the coax braid.

The shack and antenna grounds are both at one end of the 40m long wire antenna, so most of the current has to flow through the ground for some distance before reaching either earth connection. But if more ground rods are added under the length of the antenna further from the feed point, very little RF current flows in them. I think this is because the distributed inductance of the wire connecting the more distant ground rods to the common grounding point has a reactance that is large compared to the resistance of the ground connection. So I tried a "star" ground system consisting of 11 ground rods distributed around the centre of the antenna span with a radius of roughly 13m. Each rod was connected using 13m of wire to a central point insulated from ground, which was then connected back to the low-potential end of the matching transformer with a bus wire. In this way, all the ground current had to flow through an equal impedance, whichever ground rod it passed through, and checks with an RF ammeter confirmed the current in each ground rod was indeed roughly equal. With the shack ground isolated as before, the loss resistance was now 33 ohms, so a modest 11% improvement in antenna efficiency had been achieved. The loading coil inductance also had to be reduced slightly due to the added inductance in the ground connection. I then tried disconnecting some of the rods, to see how many were actually needed - the results were:

11 rods - 33R
8 rods - 34R
5 rods - 36R
3 rods - 41R
2 rods - 44R
1 rod - 55R

So the resistance associated with a single rod is about 20 - 25 ohms; there is not much to be gained by having more than 5 rods. The best that was achieved was only about 2dB better than using a single ground rod.

The ground at my QTH is a thick layer of clay, which seems to be waterlogged most of the time, so I imagine the ground conductivity is quite high. I expect grounding arrangements would have more effect where the ground conductivity was lower, and the loss resistance was higher to start with, or the antenna was very large and had a lower loss resistance - does anyone have any experience of this? If you have similar ground to mine, the moral of the story would seem to be that the location of the ground system is not very critical provided it is reasonably close to the antenna, and that there is little to be gained by having more than about 5 ground rods, unless the loss resistance of the antenna is very low to begin with.

Cheers, Jim Moritz
73 de M0BMU




<Prev in Thread] Current Thread [Next in Thread>
  • LF: Earth experiments, James Moritz <=