Hi Chris,
QRG is 136.172 kHz.
Since today the soundcard is GPS tracked ("locked") via SL and the TX
converter is in a PLL of a GPS locked ref frequency, so the whole
carrier should be quasi locked. Hope this works well and EMC problems
come up...
Accuracy could be in the range of 100 uHz now. Maybe someone can proof
that? I will try to leave a signal on Chris/4X1RF "6000" spectrogram
too, soon.
73, Stefan/DK7FC
Am 07.09.2011 18:55, schrieb Chris:
Frequency, Stefan, please?
Chris, G4AYT.
----- Original Message ----- From: "Stefan Schäfer"
<[email protected]>
To: <[email protected]>
Sent: Wednesday, September 07, 2011 5:15 PM
Subject: Re: LF: beaconing to the west II ...and to the east, north
and south...
Hello Bill,
Well, ok then i would configure SL like in the attached file (without
the specific setting to upload the captures to your grabber page). I
would prefer the noiseblanker instead of the clipper. It can be
configured very precisely (since version b18 and newer).
You could run two instances with your settings from yesterday and my usr
file simultaneously, just for fun and to see if there is an
improvement...
I think i would rather use a wide SSB filter instead of the narrow CW
filter. The noiseblanker works better then. BTW this could be a
disadvantage of my narrow ferrite antenna!
Am 07.09.2011 17:26, schrieb Bill de Carle:
What time will you start Tx?
73,
Bill VE2IQ
I'll start arround 19 UTC TXing to JA (my call a single time in
QRSS-120) and then in the late evening to the west (QRSS-60), say 21
UTC, the whole night through...
73, Stefan/DK7FC
|
