-----
Original Message -----
Sent: Tuesday, May 17, 2011 5:03 PM
Subject: Re: Re: LF: Re: Experimental QRSS-1 grabber at
DK7FC
Stefan
There is no substitute for a few watts CW
mode from a valve TX/RX and a piece of wire if we want reliable
communications, no third party involved like ISP and no EMP problems to
ZAP the fragile Chips inside an appliance operator box.
Pedal power, wind generator or small electric
generator and some Wet batteries provides the DC.
Keep it simple. This is what NFD is all
about. I once saw a small home made steam driven generator on a NFD
site, a bucket of coal and some water for the steam engine and an old
automobile 12v dynamo.
g3kev
-----
Original Message -----
Sent:
Tuesday, May 17, 2011 4:47 PM
Subject:
Fwd: Re: LF: Re: Experimental QRSS-1 grabber at DK7FC
The message seemed to be stopped by the reflector. Once again...
73, Stefan
-------- Original-Nachricht --------
Tnx to PA0A and G3KEV for the test signals! Pics attached.
73, Stefan/DK7FC
Am 17.05.2011 15:42, schrieb Stefan Schäfer:
> Mal,
>
> Could you try again. Haven't seen your transmission and didn't collect
> the captures. Now collecting and watching...
>
> 73, Stefan
> Am 17.05.2011 15:24, schrieb mal hamilton:
>> Stefan
>> Grabbers working FB on 137 Khz sensitivity restored, tested 1323 z
>> today
>> 73 de mal/g3kev
>>
>> ----- Original Message -----
>> From: "Stefan Schäfer"<[email protected]>
>> To:<[email protected]>
>> Sent: Tuesday, May 17, 2011 11:31 AM
>> Subject: LF: Experimental QRSS-1 grabber at DK7FC
>>
>>
>>> Hello LF,
>>>
>>> I just set up a temporary QRSS-1 grabber at
>>> http://www.iup.uni-heidelberg.de/schaefer_vlf/DK7FC_LF_Grabber3.html
>>> It is fast updating each 20 seconds. The scroll rate is 200 ms/pix, FFT
>>> bin width is 1.34 Hz. Maybe it helps a bit to exchange more information
>>> for strong local stations.
>>>
>>> The webpage and capture is minimized to allow fast updating. So no
>>> counters and that stuff...
>>>
>>> It is not intended to make a new alternative standard but rather to do
>>> some local experiments.
>>>
>>> Any kind of feedback is apprechiated.
>>>
>>> Vy 73, Stefan/DK7FC
>>>
>>> PS: Unfortunately i have some local noise by a SMPS here but thats just
>>> for a few hours during other experiments here by the working groups...
>>>
>
