Hello Stefan,
I use version 2.77 b13 here.
I ask it, just to be sure all 4 Spectrum labs are not pulling the SR individual
into a other direction...
Sometimes happpens something similar at my job when a cable reel starts rolling and a colleague wants to slow it down and the other
just wants him rol quicker.
They go grumbling to each other.... :-)
O.T.:
Not 100% the same, but I think these 2 cable install engineers did start grumbling to: http://www.youtube.com/watch?v=jNdxVAdz0KY
:-)
73's, Peter - PA1SDB
www.qsl.net/pa1sdb
----- Original Message -----
From: "Stefan Schäfer" <[email protected]>
To: <[email protected]>
Sent: Friday, June 01, 2012 8:10 PM
Subject: Re: LF: "SR cal" in spectrum lab question.
Hi Peter,
I'm not sure if there are new versions that do the job in one instance. But normally you need the sample rate detector in each SL
instance separately.
What version are you using?
73, Stefan/DK7FC
Am 01.06.2012 20:50, schrieb PA1SDB, Peter:
Hello...
I was wondering the following:
I have here 4x Spectrum Lab task running at one PC to serve my SUB9KHz grabber
page at www.qsl.net/pa1sdb
I use that Sampling Rate detector in all 4 Spectrum Lab tasks.
Is that OK, or need I only one Sampling Rate detector that callibrates the
other 3 tasks to ?
(one master - 3 clients without that SR cal active)
73's Peter - PA1SDB
|
