a more fundamental question.
at the bottom of the WSPR screen a red box has Rx Noise then a -dB number.
What order of dBs do you normally see in here.
regards
peter
Sep 23, 2009 11:57:43 PM, [email protected] wrote:
===========================================
Dear Graham, LF Group,
The SNR you see with Spectrum Lab will depend also on the relation between
the spectrogram bandwidth (depending mostly on the resolution of the Fast
Fourier Transform process) and the spectrum of the signal being monitored.
Usually, the signal has a larger bandwidth than the FFT "bin", so varying
amounts of signal appear in different bins. So the SNR measured from the
spectrum graph is only useful as a relative measure between signals of the
same type, without further analysis to total up the signal power in
different bins.
To get the SNR for a particular mode from the WSPR SNR data for 2500Hz BW,
you need to take the different bandwidths into account:
mode SNR(dB) = WSPR SNR - 10log(mode bandwidth / 2500Hz)
So if WSPR was giving SNR of -10dB, the SNR for PSK31 with 62Hz bandwidth
would be +6.1dB.
What SNR is actually needed for successful copy depends on the type of
modulation, the effectiveness of error correction, how good the demodulator
is, what the nature of the noise is, etc. I suppose for most modes it is
between about 0 and +several dB
Cheers, Jim moritz
73 de M0BMU
|
