Jay,
no overnight copy here
73, Rik
Quoting [email protected]:
FLdigi also works well http://www.w1hkj.com/Fldigi.html .
Jay
----- Original Message ----- From: "Rik Strobbe"
<[email protected]>
To: <[email protected]>
Sent: Saturday, February 07, 2009 5:20 PM
Subject: Re: LF: WE2XGR/2 in MFSK8
Here Stream and Multipsk are working side by side for almost 1 hour
now (fingers crossed).
However no copy so far.
I leave them running overnight.
73, Rik ON7YD - OR7T
Quoting [email protected]:
Gary
The program keeps running okay here.
A couple other points though. Unlike Multipsk one has to specify the
lower edge of the bandpass - not the middle. This is 120 Hz below the
center. In other words if 800 Hz is your received audio center
frequency set the frequency to 680. Maybe there is a way to set it to
the center...if so I havn't found it.
The bigger problem is with other applications running at the same time.
Just opened an internet browser and copy went to garbage. MultiPSK kept
decoding properly.
Jay
----- Original Message ----- From: "Gary - G4WGT" <[email protected]>
To: <[email protected]>
Sent: Saturday, February 07, 2009 4:54 PM
Subject: RE: LF: WE2XGR/2 in MFSK8
Jay, LF,
I also downloaded Stream & it runs for about 30 seconds & freezes.
73 - Gary - G4WGT.
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of
[email protected]
Sent: 07 February 2009 21:42
To: [email protected]
Subject: Re: LF: WE2XGR/2 in MFSK8
Rik and group
Confirming start at 2130Z.
Downloaded Stream earlier and was unable to get it to work. MultiPSK works
fine. May very well be
cockpit error. Will look into it.
Jay
----- Original Message ----- From: "Rik Strobbe"
<[email protected]>
To: <[email protected]>
Sent: Saturday, February 07, 2009 4:28 PM
Subject: Re: LF: WE2XGR/2 in MFSK8
Jay,
It just downloaded / installed stream (IZ8BLY).
RX / PC is on 508.5 overnight
73, Rik ON7YD - OR7T
Quoting [email protected]:
WE2XGR/2 will be transmitting in MFSK8 mode on 508.5 kHz from 2130Z -
0000Z tonight. Reports are appreciated.
When using MultiPSK as the decoder be advised that the program has been
known to occasionally go on 'walkabout' after loss of signal. Stopping
and restarting the decoder seems to solve the problem.
Jay W1VD WD2XNS WE2XGR/2
Disclaimer: http://www.kuleuven.be/cwis/email_disclaimer.htm
Disclaimer: http://www.kuleuven.be/cwis/email_disclaimer.htm
Disclaimer: http://www.kuleuven.be/cwis/email_disclaimer.htm
|