Re: LF: Re: Field Strength Meter

[CHRISTOPHER OSBORN <c.cjo@btinternet.com>]

John / Jim / Alan / LF,

Many thanks for all comments and suggestions regarding my attempts at field strength measurements.

Using G3NYK's spreadsheet I calculated my ERP as being  77 mW
(ERP deduced from measured F/S - 40 mW)

I am fortunate with the F/S measurements here as I have open, unobstructed fields to the west of me and can get away from any metal objects and trees.
I stand with the meter at arms length and slowly rotate myself 360 degrees noting that I get a null and then recording the highest value.

I tried a similar experiment in town last night and as Jim has experienced I had some unexpected readings along one of the roads for no apparent reason.

I plan to take a large number of measurements, only in open country and hopefully any errors will be averaged out.

I'll be away for a few days but will resume these experiments on my return.
No doubt I'll be notified of any c--- ups in my calculations or methods -
 HI !

73 Chris G3XIZ

James Moritz <james.moritz@btopenworld.com> wrote:

Dear Chris,

 

Interesting to see your field strength measurements - would also be interested to know how this compares to any calculated value you have for the ERP of your station.

 

A few years back, I made several hundred FS measurements on my 136kHz and 73kHz station, looking at the effects of antenna configuration, distance etc., using a mobile measuring set-up with the measuring antenna mounted on the roof of my car. I found that one could expect "random" variations within a range +/-3dB of ERP at different sites. These variations were not just random errors; one could return to the same site months later and measure the same variation in field strength. I came to the conclusion that things in the environment were causing some enhancement or reduction in field strength; presumably conductors such as wire fences, buried cables, etc. acting as parasitic antenna elements. Some sites produced much larger variations up to +/-10dB or more. On inspection there was usually a fairly likely-looking cause for this, such as overhead power lines, or large metal structures such as buildings and bridges, but there was not always anything immediately obvious to be seen. One road leading away from my house gave wildly varying results along its length - it turned out that the overhead telephone wire from my house ran along this road, and high and low FS readings were separated by about the right distance to be interpreted as a lambda = 2200m standing wave on the overhead wire. But provided a substantial number of measurements are available, it is easy to spot which measurements are suspect and check them, and to get a good average value. Something worth checking is that you get a deep directional null with a loop or ferrite rod antenna; if not, the measuring site is probably dubious. I expect if one were only to use measurement sites that were in the middle of open ground, a good distance from any large metallic objects, variations between measurements would be reduced greatly. Unfortunately, there seems to be a shortage of accessible sites like this near me...

 

Regarding the letter in RadCom, the difficulties of field strength measurements depend a lot on the frequency. I have some experience of HF FS measurements - in this range, connecting cables and any other fair sized bit of metal can become resonant, and can produce huge peaks and troughs in the results without careful attention. At VHF and above, multipath propagation becomes a headache, with multiple unwanted reflections from the ground and any nearby objects. I think LF/MF is relatively straightforward in comparison - the main difficulty being that you need to be at least several hundred metres away from the TX antenna to get good measurements. But once the problems have been identified, measurement results are usually very consistent.

 

Cheers, Jim Moritz

73 de M0BMU

---

Yahoo! Photos � NEW, now offering a quality print service from just 7p a photo.