Rik,
I make your signal 14Hz lower than Andy at the moment & not getting a hit on
the beacon Rx here.
Gary - G4WGT.
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Rik Strobbe
Sent: 01 April 2009 20:49
To: [email protected]
Subject: Re: LF: Re: QRSS / beacon test on 503.7kHz
Hello Dave,
chances might be better with a QRS viewer.
Or if the beacon software can share the soundcard you can run both.
VXO is still drifting a bit, I adjusted it to 503705Hz at 21:45 utc.
73, Rik ON7YD - OR7T
Quoting "dave.riley3" <[email protected]>:
> RR Rik,
>
> Will leave RX on 503.7 and beacon pgm. @ standard -240 seconds
>
> See you on the blue trace....
>
> TNX from Dave @ WD2XSH/17
>
>
> ----- Original Message ----- From: "Rik Strobbe"
> <[email protected]>
> To: <[email protected]>
> Sent: Wednesday, April 01, 2009 2:15 PM
> Subject: LF: QRSS / beacon test on 503.7kHz
>
>
>> Dear all,
>>
>> I just started a QRSS10 beacon on 503.7kHz (right now 503.705 but
>> it might drift down some Hz over the next hours).
>> The beacon will start every 15 minutes at +6 minutes (so xx:06,
>> xx:21, xx:36 and xx:51) and the message takes about 7,5 minutes.
>> From +6:25 to +6:30 it will be "key down" for the "blue trace" on
>> the G4GWT beacon monitor.
>> ERP is about 200mW
>>
>> 73, Rik ON7YD - OR7T
>>
>> Disclaimer: http://www.kuleuven.be/cwis/email_disclaimer.htm
>>
>>
Disclaimer: http://www.kuleuven.be/cwis/email_disclaimer.htm
|
