|
Also over here good copy Cuxhaven Germany although
very qrn
I observed also the QSY at tuning up ( abt 50 Hz
)
and switchoff "wine" do no load, going back and qsy
up 100Hz or so and then stop.
Using TEE- Antenna 12m / 20m topload, Mixer with
Ne612, 29 Mhz xtal.( IF 29 MHz)
Signal was abt s-9 and abt 10db over noise
floor.
Made a swl (LWL) report to saq
vy 73 Uwe, DK1KQ
----- Original Message -----
Sent: Saturday, July 02, 2005 8:24
PM
Subject: LF: RE: SAQ Broadcast
Dear
LF,
SAQ
signals very strong at this location. Could still be heard with 40dB
attenuation in the antenna lead. My RX set-up was a MC1496
mixer up to 7.0 MHz and then into an ICOM PCR-1000. No preamp. I used my usual
LF Marconi, but with a ferrite pot-core to resonate at 17.2
kHz.
I
could clearly see the "spacer" signal during key-up periods (using Spectran).
I think the whiff of hot oil and transformer varnish was a trick of my
imagination!
73,
Dave
G3WCB IO91RM.
Dear LF Group,
Good reception of the SAQ broadcast a little
after 1230 utc today - the QRN level seems to be lower than it usually is
when SAQ is active, so a nice clear signal. Today's broadcast message was
about UNESCO inauguration of the site, paying tribute to EFW Alexanderson
and recognising the impact of radio communications. Hopefully, the
noise will remain low for tomorrow's broadcasts too.
Cheers, Jim Moritz
73 de
M0BMU
| 