----- Original Message -----
From: James Moritz <[email protected]>
Subject: LF: Re: GPS Coherent PSK Transmission
Dear Andy, LF Group,
I copied the G4JNT PSK beacon last night; assuming I have the start
times/polarity correct the sequence was:
011 010 111 001 011
I found two methods of demodulating the signal using general-purpose
equipment - the first is simply to produce a spectrogram, using parameters
for 30s dots. The "key clicks" produced by the phase transitions are
visible as a spreading of the trace. Setting Spectrum Lab to produce 30s
time markers made it fairly easy to identify the sequence. I noticed a
period around 2250 when there were no phase transitions for several
minutes, but then the sequence returned to normal.
The second method was to look at the phase directly - to do this I fed the
RX audio into one channel of a 'scope, and fed a stable audio frequency
equal to the BFO offset into the other channel. The frequency error of the
RX and locally generated tone was small enough so that the phase
difference
between the two traces only changed a fraction of a cycle in several
minutes, so it was easy to see an abrupt phase change when it occurred.
Due
to QRM/QRN, I found that to make the beacon signal clearly visible on the
scope, a very narrow bandwidth audio filter (<10Hz) was required; this was
also implemented using Spectrum Lab. Even then, the apparent phase of the
signal bounced around by some 10s of degrees due to noise, and noise
spikes
could cause a temporary phase inversion, so a lot of concentration was
required to get the sequence. With a strong signal, the traces are quite
stable, so you could use this method to detect an abrupt phase change, or
measure frequency to millihertz resolution quite easily.
Although good fun, neither of these methods is really viable for DX
reception, since they don't integrate the signal over the whole bit
period,
let alone over several sequences - a bit like decoding QRSS by ear. Andy's
signal was about S3 at my QTH, but hard to actually hear due to a
permanent
S6 carrier I get on about 136.65kHz, a real nuisance for manual CW
operation - does anyone else hear this?
Yes Jim I have a permanent carrier (Loran line ?) on 136.647 by my
measurment which I call the south coast mystery signal ! since people
further inland dont seem to hear it. I once tried to DF it and belive it
originates from E.France,but I could be wrong. It makes a good calibration
marker since the freq. is very constant. 73s Laurie.
Cheers, Jim Moritz
73 de M0BMU
| 