Hi Andy, I think I and probably Brian would be interested in this. Would you
have the frequency increments around say an preloaded nominal frequency in
the PIC and accept Alberto's serial code ?? or were you just intending to
look for frequency words ?? and we write the coding algoritm. With your
'synch' system this would mabe enable GPS timed Jason to be sent ?? Though I
am not sure whether this would be an advantage without some "tweaking" to
Alberto's decoder.
Copy of Johan's 80m QRPP signal a few nights ago showed that the signal was
detectable in the waterfall but not really decodable (Ver 092 or 3 at the
time) due to the high level of static
Cheers de Alan G3NYK
[email protected]
-----Original Message-----
From: Talbot Andrew <[email protected]>
To: '[email protected]' <[email protected]>
Date: 24 July 2002 12:45
Subject: LF: Jason code on DDS Module
Is anyone interested in adding JASON support to my DDS board controller ?
Probably by issuing a "J" command which puts the PIC controller into a loop
looking for 9600 baud words on its serial port, then requiring a reset to
get back to normal. Or by setting a link / switch on one of the spare I/O
pins.
If there is enough demand this could be done with higher priority !
Andy G4JNT
"The Information contained in this E-Mail and any subsequent
correspondence"
"is private and is intended solely for the intended recipient(s)."
"For those other than the recipient any disclosure, copying, distribution,
"
"or any action taken or omitted to be taken in reliance on such information
is"
"prohibited and may be unlawful."
| 