Dear Group, A QRSS60 detection at 5.2 km is the best DX for yours truly to date. Although there was a detection at 7 km, this was probably via conduction from a nearby mains line. The RX is a DK7FC V
Thanks Edgar, Tried putting it 50 dB lower but still no trace of signals or noise! Cheers Joe Hi Joe, Try reducing the minimum amplitude range and see if that helps. On the Spectrum ..(2) tab. Regard
Hi Joe, Probably you need to change the FFT input center frequency in the FFT register card. Choose 'complex, with internal frequency shift' and set this shift to your desired frequency. 73, Stefan A
Hi Joe, Possibly no help to you but. Using V2.81 b14 a signal was used to test changing from Quick Settings QRSS60 to QRSS120 and back. Two minute signal two minutes silence. Once the sound card thre
Hello Joe, I will check the QRSS120 configuration soon, maybe I had copied the settings from a computer where the input level (soundcard) was rather high, and the signal in your case is much weaker.
Hi Edgar, Stefan and Wolf, Your help is muchly appreciated. Edgar seems to have no problem switching between qrss60/120. I tried Stefan's settings but still no sigs on the screen. The monitor scope i
Hi Joe, to short the story, maybe you like to install Teamviewer software and send me a temporary password to i can do the settings on your PC remotely while you can watch what was done.. So far i've
Hi All Just about SpectrumLab. I have a question Would like to know how to add those featured "palette versus dB" little charts found usually in grabbers. At the moment I'm just using this configurat
Hi Luis, The presence and position of the 'waterfall colour to dB' legend is configured in SL's Screen Capture settings: http://www.qsl.net/dl4yhf/speclab/perisced.htm#screen_capture Set the checkbox
Thank you very much for the information Wolf I take this opportunity to thank you for SpectrumLab. Congratulations for this software masterpiece. One never ends findind features and all works smoothl