Signals from VO1NA, 2015-11-25/26 So far decoded: time Eb/N0 T-Offset Phase 00:00 no decode 00:30 no decode 01:00 10.8 dB +2.9 0 0 30 30 01:30 8.4 dB +4.2 -90 -90 -60 -60 02:00 9.7 dB +5.7 -30 -30 0
Unfortunately I went to bed too early and didn't start data saves. 73, Markus --Ursprüngliche Mitteilung-- Von: jcraig <[email protected]> An: rsgb_lf_group <[email protected]> Verschickt: Do,
Good day all, here the results of my decodes. I have used the time offsets indicated by Markus and Paul (thanks !) to start searching the sequence. Signal is very weak here and there is no possibili
Markus Paul and Domenico, Group I have new message 5 characters 512 symbols and hopefully corrected the timing offset a bit. Will start in 1 minute at 2000 utc and on the half hour. Running 50 watts
Are these transmission using 1s or 2s symbols ? Missed the 2000 sessin, but I'll record some of the later ones. Andy On 26 November 2015 at 19:59, <[email protected]> wrote: Markus Paul and Domenico, Gro
Final result time Eb/N0 T-Offset Phase 00:00 no decode, tried very hard 00:30 -0.8 dB +1.8 -30 -60 -60 -90 (rank 35975 BER 36.8%) 01:00 10.8 dB +2.9 0 0 30 30 01:30 8.4 dB +4.2 -90 -90 -60 -60 02:00
Decoded straight away with zero T offset: found rank 29: VO1NA ps [ 1 180 180 180 180] re-encode 184/512 ber 3.59e-01 Es/N0=-11.8 Eb/N0=0.5 effrate=1/17.07 I'll try sweeping in the T dimension to see
Hi Andy and thanks for tip of putting the diode across the gate of the PA MOSFET in your posting a few months ago. I'm using the class E amp at the moment. The XOR can idle with high output so I deco
Decoded straight away with zero T offset: found rank 29: VO1NA ps [ 1 180 180 180 180] re-encode 184/512 ber 3.59e-01 Es/N0=-11.8 Eb/N0=0.5 effrate=1/17.07 I'll try sweeping in the T dimens
Paul, The exciter quit sometime during the night. Perhaps around 0400! Nice numbers for 50 watts and poor timing on my end! I know someone who might have a source of GPS PPS to correct this problem.
RR. I see some urgent GUI mods needed At the moment, to record successive sessions, each one has to be started manually (although it does have auto restart at selectable time boundaries). So I have
512 chars, 2 seconds each, duration 17'04" What is the duration of these transmissions, 512 chars at what rate ? Andy I have new message 5 characters 512 symbols start in 1 minute at 2000 utc and on
Message: 5 chars Coding: 8K19A Symbols: 512 at 2 seconds each Duration: 1024 seconds, 00:17:04.00 Best decode here is at T offset +0.8 Eb/N0=5.4 phase 150 150 180 180 I run 10 copies of the decoder i
Successful decode of your callsign. Inline images 1 On 26 November 2015 at 20:33, <[email protected]> wrote: Hi Andy and thanks for tip of putting the diode across the gate of the PA MOSFET in your posti
There is a faint trace visible on the waterfall at the moment 0.122Hz bins, . I guess you're in carrier mode. During the transmission, there were occasional short lines there, corresponding pres
20:30 message found rank 35302: VO1NA ps [ 28 -30 -30 0 0] re-encode 188/512 ber 3.67e-01 Es/N0=-12.3 Eb/N0=0.0 at offset again T=+0.8, so far no better decode so could be the clock is no longer drif
2030 decode was fine, callsign decoded after about 4% - did the graphic dump of the screen pass through the reflector ? 2100 decode not so sucesssful WBPZO which is wrong ? Rank 11069 Es/N0 -14.
Hi Andy and Paul, Happy to hear of your decode, Andy. As for the clock, I actually had to reset the system because the pause time was incorrect. The 2030 one was started by yours truly listening to C