yes, Markus, in 80dgr one will find the maximal FS - normally. if there are some gaps in the line one may fill them by roating to abt 60dgr. aurora effect? GL Uwe/dj8wx Von: rsgb_lf_group@blacksheep.
Hi all, ZOA on 8270.004Hz in mode A0 since 1611utc. will ZAP it at 1729utc and be ZOA agn on the same QRG in mode Op-4H at 1730utc for hopefully abt 9 hours. GL Uwe/dj8wx Von: rsgb_lf_group@blackshee
sri, OMs, I had to switch off the TX. the WX is too bad. waiting for sun- or moonshine Uwe/dj8wx Von: [email protected] Gesendet: 07.01.2014 12:37 An: [email protected] Betreff:
the TX is off because of freezing rain. sri. GL Uwe/dj8wx Von: [email protected] Gesendet: 20.01.2014 19:29 An: [email protected] Betreff: Re: Re: Re: VLF: DJ8WX 8270.004 Hz no,
no, Markus, I guess Im not. the TX is on the air agn since 1821utc. GL Uwe Von: [email protected] Gesendet: 20.01.2014 12:27 An: [email protected] Betreff: Re: Re: VLF: DJ8WX 82
Hi Paul and Markus, the chaos at 0200utc seems to be confirmed bei Pauls phase measurements: 2014-01-19_02:00:00 0.23 fT -171.5deg, with 171,5dgr as the biggest anomality. Markus, the aerial hasnt be
Yes, Markus, my TX has been ZOA with SpecLab set to phase correction. all grabbers show a vy clean line never seen before. Thanks for that .USR file. But….. I had problems finding a proper sou
Hi all, the transmission stoped last night at abt 0230utc because the mains collapsed. coming night next try. GL Uwe/dj8wx BTW. if wanted I could switch to Op-4H. Von: [email protected] Ge
<But why not insert the meter at the low voltage side of the loading coil, or in the ground lead? Markus, thats the way I did it. using shunts down to 5Ohm. no chance. I could try it with output pwrs
Hi Markus, and the FS will rise one day when I take some huge branches down. the twigs contact some of the top wires. thanks for information Uwe/dj8wx Von: [email protected] Gesendet: 19.0
Hi Peter, There has been chaos around 0200utc: 2014-01-19 02:00:12 PPS zero-crossing too flat 2014-01-19 02:00:12 Timestamp didn't pass plausibility check ! 2014-01-19 02:00:13 Timestamp didn't pass
since 1407utc I was playing around with the settings. that caused mni "glitches". so I switch the PA off now at 1500utc to make some "dry practices". until later Uwe Von: [email protected]
Hi Markus, just now reading your mail. the switch off time was some min after you sent it.. sri for that. now the TX will stay on the air until tomorrow abt 0900utc. Hopefully Mal reads this. GL Uwe
Hi Markus, now since 1238utc ZOA in 1pps_PLL.usr mode on 8270.004Hz we will see GL Uwe Von: [email protected] Gesendet: 23.01.2014 00:24 An: [email protected] Kopie: Paul@abelia
the TX is now on the air with carrier only, in phase corr PLL mode of course. GL Uwe/dj8wx Von: [email protected] Gesendet: 26.02.2014 17:53 An: [email protected] Betreff: Re: R
Hi Peter, I did´nt change anything. the wx is and was fine. GL Uwe/dj8wx Von: [email protected] Gesendet: 03.02.2014 08:28 An: [email protected] Betreff: LF: 8270.005Hz :
yes, Peter, it is CW in QRSS600. phase correction mode. I tried to get a "W" out of the digimode terminal. but the results are some strokes. GL Uwe/dj8wx Von: [email protected] Gesendet: 0
Hi Peter and Markus, your mail came prompt, Peter. I tried, or better, I am still trying SpecLabs Castle in mode phase contr PLL. now on the air without phase control in Castle ca one hour per dash.