I intend ordering either one or two of the 18m fiberglass masts produced in Germany by VON DER LEY and wondered if anyone else in the UK would be interested in ordering one at the same time, to cut d
Hello all, Just been chatting to Tom G3OLB, huge signal here with his new QRO TX,and the signal we are hearing is EI0CF in beacon mode! I'm not sure if all the water here has affected my head and hen
Hello All, The above was received last night at about 23.00 GMT on 136.25kHz at5/4/9. Still there this morning, slightly weaker. Anyone else hearing him? Regards Mike-GW4HXO.
--Original Message-- Hi Mike, What a most impressive antenna! I believe the distance between us to be 174 km. To confirm your reports: Usual power: 589 (Normally abt 300W out 3.5/4 amp ant current)
Hello all, Very pleased to work Dave cross band 73/136kHz this morning. His signal peaking 5.7.9.manual cw. His report to me on 136, 5.6.9 with his antenna tuned. to 73kHz! He then worked Tom G3OLB X
Dave, First time ever- hearing a signal on 72.8kHz. Aurally 5.5.9. Excellent copy Dave. Would like to work you X band. Will be about for next 2 hours or so. Time now 09.10 utc. 73 Mike GW4HXO.
Hello Mike & all, Don't be so sure Mike about the insurances companies having to pay out for all that equipment.A few years ago a lightening strike occured in a field a few hundred meters from my hom
Excellent signals on 17.2 khz received here in South West Wales 5/8/9 at 0830 utc. Many thanks to all concerned Hope to work you on 136 73s Mike GW4HXO.
Hello Andrew, This firm stocks a good range of Amidon ferrite ringsJAB Electronic Components PO Box 5774 Birmingham B44 8PJ e mail [email protected] His catalogue is currently out of print but he
Thanks to G0MRF/G3NYK/G3YXM & GW4ALG for prompt replies. Steve, GW4ALG wrote . While you still have that rogue LF transmitter (cleverly disguised as a TV receiver), is there any chance of doing some
Hello All, On the 30th August I wrote purchased & installed a new Panasonic TX-25 CK1 TV receiver to replace an older one of same make. To my horror, I found that it radiates a strong rough carrier o
Hello all, To solder litz wire of the variety used by Decca. Strip off about 10 -20 mm of the plastic/cotton covering Dip the exposed end in paint stripper for a few minutes. Use a tooth brush to rem
Hello All, At 15.15 the old Alexanderson tx transmitted two short messages on 17.2kHz -- " v v v cq cq de SAQ = Grimeton 5/9 = the people of the world on July 2 1925 my great grandfather inaugurated
In the last e mail from Derek G3GRO his address was-- [email protected] Regards Mike GW4HXO. --Original Message-- >>>>>>>>>>> Subject: Re: LF: litz In a message dated 11/10/01 8:59:04 AM GMT Stan
Hello Wolf, Many thanks for info. Too old for camping or mosquitos !! 73 Mike. GW4HXO. --Original Message-- <<<<<<<<> Hello Mike, The HAM Radio in Friedrichshafen this year is from June 28 to 30. If
