For DJ7KL, thanks for calling me this morning, but QSO is not complete because I did not get a report from you. There was a combination of factors: -your signal was going up and down in QSB -I had so
beaconing right now around 136.320kHz in 30 sec/dot mode with "low power" until 2200utc or so reports are welcome Sorry for DJ6GT, almost complete QSO, but computer crashed and took very long time to
This morning someone called me in QRSS3 mode. I think it was OK2BVG. Unfortunatly the signal was just to weak to copy in QRSS3, so I started to TX in QRSS 5 and later in QRSS 10. QRZ Sorry, but the o
Hi Dave, I stop now..... power has been really low about 28V/3A DC input............. Have to take antenna down.....strong wind gusts here.... Maybe I'll be on later in the week, with a bit higher vo
Hello all, This evening I want to do some more beaconing on 136.315,5kHz. After the sucsessfull test yesterday, I will do it again, but this time with less power.... With around 100Watt RF-output rec
Hello all, still on beaconing 136.315,5kHz. Very glad to see that even with 20Watt ouput, my signal comes through in western Europe. I will switch over to 60seconds/dot at around 20.00 utc (so, in a
Around 20.30utc I reduced the DC input to about 19Watts, estimated RF-output 15Watt now Speed 60 seconds/dot Let's see if this comes through..... 73 Dick , PA4VHF (136.315,5kHz)
Hello everybody, Thank you all for the reports here on the reflector. I am really glad to see my signal appearing so well. Equipement was as follows: X-tal controlled oscillator + divider, and TX lik
Hello all, I just switched off the test beacon on about 136.320kHz. Some problems with the power supply; will try to set up another one later, and also put a fan on the TX. Some parts get warm... 73
QRV since 17ut until 20ut with QRSS 30, now at QRSS60 on 136,318.75kHz Power 140W DC input into 6m vertical with topload in backyard. Dick, PA4VHF-JO32EG
Hello all, QSL's for LX/PA6Z will send as soon as possible. I will write and sign them personally for all 136kHz contacts. But, be patient, as we are rather busy now, it can take some more months. I
Hallo Marco, Zur zeit benutze ich ein T-antenne. Dass horizontale teil besteht aus 4 parallele drahte je 7m lang und etwa 40-50cm aus ein ander. Dass horizontal teil hangt auf etwa 7m uber den grund.
