Return to KLUBNL.PL main page

rsgb_lf_group
[Top] [All Lists]

Re: LF: Receivers and power-line noise

To: [email protected]
Subject: Re: LF: Receivers and power-line noise
From: "Hans-Joachim Brandt" <[email protected]>
Date: Fri, 19 Nov 1999 01:55:29 +0100
References: <000901bf31b9$8a580bc0$3190bc3e@default>
Reply-to: [email protected]
Sender: <[email protected]>
Dear Kevin,

so far I have not encountered problems with rfi from the mains supply. But I like to block every rectifier diode with several nanofarad in all my home brew power supplies (this also will suppress the 50 Hz hum in direct conversion receivers) but I have also found that this is seldom done in commercial power supplies and therefore may cause problems, even from our neighbours.

Concerning battery supplies I have also found that typical voltage stabilizer ICs like 78xx, even when blocked according to manufacturers recommendations (with 0,33 to 0,47 uF) will generate LF noise at the input side, unless the input is blocked more heavily with 6,8 uF to 10 uF low loss electrolytics.

73 Ha-Jo, DJ1ZB


Kevin Ravenhill schrieb:
Hi all,

This may well have been mentioned before on this reflector, so apologies to
those concerned if it's going back over old ground.

For anyone plagued by power line "hash" when receiving on LF, particularly
when using wire antennas, it's worth checking the cleanliness of the DC
power supply which is being used to power the receiving setup.

I have found out the hard way that the rectifier diodes in some power
supplies can generate truly enormous amounts of harmonic hash at these
frequencies. I have not checked too closely but I assume this is simply
being re-radiated through the transformer and into the mains wiring. There
is EC EMC legislation relevant to this aspect of power supply design, but
I'm not sure how effective this is in "special cases" such as our very weak
signal conditions.

I have tried several power units ranging from simple regulated "plug-top"
types to more complex heavy current 13.8V PSUs specifically designed for
powering radio gear. I currently use a small double-insulated (i.e. no mains
earth connection) plug-top PSU to power my receiver. This was originally so
bad that it completely wiped out reception on my AKD HF3 below about 2MHz
(note that this PSU was actually intended for this receiver!). In this case
the problem was cured by the simple expedient of fitting a 0.1uF ceramic
capacitor across the transformer secondary feed to the bridge rectifier, but
this is not necessarily a cure for all situations. Lots of lossy ferrite
etc. on the mains side may be called for!

My Daiwa 13.8V 12A unit is much better in this respect but does still
introduce a small level of extra noise. This is not really significant
enough to warrant modification though. A slightly cheaper grade of 13.8V 5A
PSU was tested and this proved too noisy to be usable without extensive
modification.

Finally, I have a multi-output variable voltage lab-type PSU for bench work
which has also proved too noisy to power the LF gear as it stands.

I suppose the surest way to eliminate this kind of noise would be to run the
receiving gear from batteries, which would also get round the problem of
noise directly coupled from the mains. I would be interested to know how
many other people have encountered similar problems with LF reception.

73

Kevin, G1HDQ





<Prev in Thread] Current Thread [Next in Thread>