Message-ID: <0aec01c2cb70$9913c2e0$0101a8c0@athlon>
From: "Dave Brown" <tractorb@ihug.co.nz>
To: rsgb_lf_group@blacksheep.org
References: <001a01c2caa4$c3557480$48a3edc2@oemcomputer>
Date: Mon, 3 Feb 2003 23:39:57 +1300
MIME-Version: 1.0
Subject: LF: Re: Fw: Jason test yesterday
Content-Type: text/plain; charset=iso-8859-1; format=flowed
Content-Transfer-Encoding: 8bit
Sender: <owner-rsgb_lf_group@blacksheep.org>
Precedence: bulk
Reply-To: rsgb_lf_group@blacksheep.org

Murray
A live one in SM5!!

Cheers
 Dave


----- Original Message -----
From: "Urban ekholm" <urban.ekholm@hem-pc.bip.net>
To: "RSGB-LF-group" <rsgb_lf_group@blacksheep.org>
Sent: Sunday, February 02, 2003 11:20 PM
Subject: LF: Fw: Jason test yesterday


Hello !

Many thanks to those who listened to my very first test with Jason and who
sent a report. I am very glad to hear that it was readable.
I am using the ZL1BPU exciter and was running between 350 and 450W input to
a 15m vertical with two toploading wires 1m apart

The frequency was more accurate than expected. I have no means of measuring
the frequency accurately. Calibration has been made against WWV on 10Mhz,
however in normal room temperature.

Unfortunately I cannot receive Jason properly yet. My old TR7 is too
unstable (no "japanese wonders" here). The Drake VFO never stops drifting
completely. When it is fully warmed up (after about 1hour) it still drifts
very slowly up and down about 1hz. Some letters are received OK followed by
garbage and then some letters ok again.

However, I am building a receiver only for 136 and there I use a VFO running
at about 6Mhz divided down to about 244khz and mix with 136 to an IF of
108khz. This VFO is completely stable in normal room temperature after about
30min warm up and gives perfect JAson readability when tested "on the
table". However the rx is still in the experimenting stage mounted on a
piece of wood (yes !) and has no AGC yet.
If anyone is interested in the "appearance" of this contraption just mail
me.

Using equipment in the /5 QTH though is another matter temperaturewise.
Normal temperature wintertime is +5°C indoors so it takes some time to get a
pleasant temperature and to get the gear stable.

Jim M0MBU:
Yes, I was calling some CQ:s on CW after the Jason test. This is my very
first report that I was being heard in Britain on normal CW so I am very
glad also for that. Unfortunately the noise level with me was much higher
than normal yesterday so I did not hear anything.

The input on normal CW is about 1100W and I get much more radiated power now
when the ground is frozen. The feedpoint impedance is now ~40ohm compared to
slightly above 100ohms normally.
73,
Urban -SM5EUF