From: "Mike Dennison" <mike.dennison@ntlworld.com>
To: rsgb_lf_group@blacksheep.org
Date: Tue, 12 Apr 2011 17:58:33 +0100
MIME-Version: 1.0
Message-ID: <4DA492C9.4329.AAE777@mike.dennison.ntlworld.com>
Content-description: Mail message body
Subject: LF: Insulating tape / Decca repair
Content-type: text/plain; charset=US-ASCII
Content-transfer-encoding: 7BIT
Sender: owner-rsgb_lf_group@blacksheep.org
Precedence: bulk
Reply-To: rsgb_lf_group@blacksheep.org


Further to my report on the failed combiner/output transformer in my 
Decca QRO Tx, I have dismantled the transformer. The really good news 
is that the huge (85mm dia) ferrite pot was not glued at all, and was 
easily unclamped. The internal wires were more difficult, being 
wrapped with cloth tape that seems to have been soaked in hard glue.

I finally got to the secondary coil and found the shorted turn. That 
coil comprises three layers wound on top of each other, but the cloth 
wrapping was inadequate in one place, resulting in one turn from the 
top layer being adjacent to one on the bottom layer, and thus 
providing a higher voltage gradient than intended and shorting 
several turns.

So all I have to do is to improve the construction (to avoid the 
voltage gradient) and re-assemble. I will wrap some sleeving over the 
slightly charred wires where the short occurred.

I need some advice on what to use to replace the glue-soaked cloth 
tape. It needs to fix the turns and provide a high degree of 
insulation. I could use ordinary plastic tape but it may suffer from 
possible high temperatures (It is physically difficult to check 
whether the transformer gets hot whilst transmitting for long 
periods, but it's certainly likely).

I have looked at the Maplin catalogue and they do "Silicone Self 
Fusing Repair Tape" which seems to resist high temperatures (up to 
260 deg C) and high voltages (it actually says "7,000 volts/20mil 
(0.51mm) dielectric strength", which I don't really understand).

Should I replace the wire, or perhaps just its insulation? It is 
solid, enamelled and insulated with some brown cloth or paper 
(similar to the glue-soaked cloth) and is in good condition away from 
the fault. Outside diameter is 2mm. 

Any suggestions or advice would be gratefully received.

Mike, G3XDV
==========