Message-ID: <001501c98979$d77b9b20$8d01a8c0@JAYDELL>
From: <jrusgrove@comcast.net>
To: <rsgb_lf_group@blacksheep.org>
References: <007a01c98928$ecb21240$8d01a8c0@JAYDELL><20090207222824.23xd7nm9mlr4ok48@webmail4.kuleuven.be><002001c9896c$d7da48d0$8d01a8c0@JAYDELL><008e01c9896e$a7743af0$6401a8c0@asus><004101c98970$67dba480$8d01a8c0@JAYDELL> <20090207232025.oujv32k40mkowc80@webmail4.kuleuven.be>
Date: Sat, 7 Feb 2009 18:14:35 -0500
MIME-Version: 1.0
Subject: Re: LF: WE2XGR/2 in MFSK8
Content-Type: text/plain;
	format=flowed;
	charset="iso-8859-1";
	reply-type=response
Content-Transfer-Encoding: 7bit
Sender: owner-rsgb_lf_group@blacksheep.org
Precedence: bulk
Reply-To: rsgb_lf_group@blacksheep.org


FLdigi also works well http://www.w1hkj.com/Fldigi.html .

Jay

----- Original Message ----- 
From: "Rik Strobbe" <Rik.Strobbe@fys.kuleuven.be>
To: <rsgb_lf_group@blacksheep.org>
Sent: Saturday, February 07, 2009 5:20 PM
Subject: Re: LF: WE2XGR/2 in MFSK8


Here Stream and Multipsk are working side by side for almost 1 hour  
now (fingers crossed).
However no copy so far.
I leave them running overnight.

73, Rik  ON7YD - OR7T

Quoting jrusgrove@comcast.net:

> Gary
>
> The program keeps running okay here.
>
> A couple other points though. Unlike Multipsk one has to specify the
> lower edge of the bandpass - not the middle. This is 120 Hz below the
> center. In other words if 800 Hz is your received audio center
> frequency set the frequency to 680. Maybe there is a way to set it to
> the center...if so I havn't found it.
>
> The bigger problem is with other applications running at the same time.
> Just opened an internet browser and copy went to garbage. MultiPSK kept
> decoding properly.
>
> Jay
>
>
> ----- Original Message ----- From: "Gary - G4WGT" <g4wgt@tiscali.co.uk>
> To: <rsgb_lf_group@blacksheep.org>
> Sent: Saturday, February 07, 2009 4:54 PM
> Subject: RE: LF: WE2XGR/2 in MFSK8
>
>
>> Jay, LF,
>>
>> I also downloaded Stream & it runs for about 30 seconds & freezes.
>>
>> 73 - Gary - G4WGT.
>>
>> -----Original Message-----
>> From: owner-rsgb_lf_group@blacksheep.org
>> [mailto:owner-rsgb_lf_group@blacksheep.org] On Behalf Of
>> jrusgrove@comcast.net
>> Sent: 07 February 2009 21:42
>> To: rsgb_lf_group@blacksheep.org
>> Subject: Re: LF: WE2XGR/2 in MFSK8
>>
>> Rik and group
>>
>> Confirming start at 2130Z.
>>
>> Downloaded Stream earlier and was unable to get it to work. MultiPSK works
>> fine. May very well be
>> cockpit error. Will  look into it.
>>
>> Jay
>>
>>
>> ----- Original Message ----- From: "Rik Strobbe"   
>> <Rik.Strobbe@fys.kuleuven.be>
>> To: <rsgb_lf_group@blacksheep.org>
>> Sent: Saturday, February 07, 2009 4:28 PM
>> Subject: Re: LF: WE2XGR/2 in MFSK8
>>
>>
>>> Jay,
>>>
>>> It just downloaded / installed stream (IZ8BLY).
>>> RX / PC is on 508.5 overnight
>>>
>>> 73, Rik  ON7YD - OR7T
>>>
>>> Quoting jrusgrove@comcast.net:
>>>
>>>> WE2XGR/2 will be transmitting in MFSK8 mode on 508.5 kHz from 2130Z -
>>>> 0000Z tonight. Reports are appreciated.
>>>>
>>>> When using MultiPSK as the decoder be advised that the program has been
>>>> known to occasionally go on 'walkabout' after loss of signal. Stopping
>>>> and restarting the decoder seems to solve the problem.
>>>>
>>>> Jay  W1VD  WD2XNS  WE2XGR/2
>>>
>>>
>>>
>>> Disclaimer: http://www.kuleuven.be/cwis/email_disclaimer.htm
>>>
>>>
>>
>>
>>



Disclaimer: http://www.kuleuven.be/cwis/email_disclaimer.htm